Garage door won't close: sensor repair in Harrison

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (914) 825-0187

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Harrison, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Belt-drive garage door opener on the ceiling rail

Doors that won't close in Harrison

Downtown Harrison grew up after the railroad arrived, and its older two-family and single-family houses have small garages on tight lots, with sensors in the path of every bumper. In Brentwood, mid-century homes have original attached garages. West Harrison and Silver Lake are hillier, with sloped driveways that carry water and leaves to the door. In Purchase, large properties have multi-bay garages and long wire runs. In the gated and condo communities, garages are uniform and close together, and a neighbor's landscaper is as likely to blow leaves into your doorway as your own. Check the two lights first.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Harrison

  • West Harrison: Along Lake Street near Silver Lake Park, with mid-century houses, colonials and townhouses.
  • Silver Lake: A sought-after section of West Harrison with newer colonials and townhome communities.

See the full Harrison service area.

Leave the door where it is and call.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 825-0187
Call (914) 825-0187